Viking Access G5 Linear Arm Operator

The Viking G-5™, leads the industry in linear actuator swing gate operators. This new design boasts a maximum gate capacity of 2000 Lbs and 100% duty cycle operation, making it unlike any other. Featuring a convenient electronic manual release switch and pre-wired for easy and quick installation. The G-5™ is now powered by the V-Flex control board, including a speed control dial and diagnostic LCD display. This new design is solar efficient and ready to be powered with low voltage wiring, allowing versatility of installations. The G-5™ offers an increased 3 year limited Manufacturer Warranty, along with ETL and UL compliance.

IMPORTANT: SECONDARY PROTECTION MUST BE INSTALLED

REQUIRED BY UL 325, an approved MONITORED secondary entrapment protection sensor is REQUIRED to be installed in all areas accessible to potential entrapment and pinch points. At least ONE monitored "10K Resistor Based" sensor MUST be connected or OPERATOR WILL NOT RUN.

The following devices comply with UL 325 and have been tested for use with Viking Access Systems gate operators:

• Photoelectric Beam (non-contact sensor) - MILLER EDGE 10K Resistor based
• Edge Sensor (contact sensor) - MILLER EDGE 10K Resistor based model ME110-T2, ME120-T2, MGR20-T2, MGS20-T2

Suitable Gate Dimensions:

Features

• Plug & Play connection for the Viking wireless expansion products
• Viking Konnect - Wireless Kit provides secure and reliable wireless communication when the application requires two single ECUs
• Viking Monitor - Remote access to the control board settings, operator diagnostics, controls, gate status and error notifications, all from the convenience of a computer or any compatible hand held device
• Standard Battery Backup provides 400 continuous cycles at 100% duty cycle
• With Viking's "True" Battery Backup System, batteries are not used during normal operations, maximizing battery life
• Advanced lightning strike protection up to 20,000 volts / 10,000 amps
• On-board surge protection monitoring
• Powder coating on aluminum alloy chassis provides long Lasting protection against corrosion
• Operational Voltage – 24 VDC 1/2 HP
• Main Power Source Options – 120/240 VAC Single Phase
• Operating Angle – 135° max
• Battery Backup – 400 Full Contin. Cycles (1500 lbs)
• Operating Speed – 15-18 seconds per 90°
• Max Gate Capacity – 2000 lbs/ 10' or 800 lbs/ 18'
• Max Duty Cycle – 100% Contin. Cycle