Viking Access H10SPS Slide Gate Operator

The H10 Slide Gate Operator features the V-Flex control board with an on-board diagnostics LCD display and a removable power supply box allowing for a low voltage wiring option. The H10 also has our new Smart Positioning System, which detects the absolute position of the gate at any instant during its operation regardless of electrical power and without requiring a re-learn cycle. This detection is possible thanks to the innovative combination of sensors and a gearbox mechanism added to the main drive of the operator. The new chassis design provides easy viewing of the controls and integrated post-mount provisions. Featuring a true 1 HP motor that increases the gate capacity of up to 2200 lbs. The H10 includes simple push-button digital limits setup, convenient access to the switch for manual release, Viking™s true battery backup system and a built-in heater, making this operator an excellent choice for both your residential and high traffic properties. Viking provides a 5-year limited Manufacturer Warranty for the H-10™.

Features

• 24 VDC with 1 HP Motor
• 120/240 VAC Single Phase
• Two 12 VDC 7 Ah Batteries
• 100 Full Contin. Cycles (2200 lbs) on Battery Backup
• 12" Per Second Operating Speed
• -20°F up to +160°F Operating Temperature
• 2200 Lbs/ 75' Max Gate Capacity
• 100% Continuous Duty Cycle
• Plug & Play connection for the Viking wireless accesssory products
• Viking Konnect - Wireless Kit provides secure and reliable wireless dual gate communication when the application requires two gate operators working in tandem
• Viking Monitor - Remote access to the control board settings, operator diagnostics, controls, gate status and error notifications, all from the convenience of a computer or any compatible hand held device
• Standard Battery Backup provides 100 continuous cycles at 100% duty cycle
• With Viking's "True" Battery Backup System, batteries are not used during normal operations, maximizing battery life
• Advanced lightning strike protection up to 20,000 volts / 10,000 amps
• On-board surge protection monitoring
• Adaptive digital limits ensure consistency at the end of travel of the gate
• Gate position detection, regardless of power status
• Limits are retained even after manual operation during complete power failure
• Multi-Layer Corrosion Protection
• G90 Galvanized
• Clear Zinc Plating
• UV Rated Powder Coating
• 1/4" Steel Chassis
• Built-in heater for operating temperatures down to -20° F
• This will allow you run your operator in the coldest conditions
• On-board LCD screen displays voltages, amps, gate status and diagnostics
• Conforms to ANSI/CAN/UL325

IMPORTANT: SECONDARY PROTECTION MUST BE INSTALLED

REQUIRED BY UL 325, an approved MONITORED secondary entrapment protection sensor is REQUIRED to be installed in all areas accessible to potential entrapment and pinch points. At least TWO monitored "10K Resistor Based" sensors MUST be connected or OPERATOR WILL NOT RUN.

The following devices comply with UL 325 and have been tested for use with Viking Access Systems gate operators:

• Photoelectric Beam (non-contact sensor) - 10K Resistor based
• Edge Sensor (contact sensor) - MILLER EDGE 10K Resistor based model ME110-T2, ME120-T2, MGR20-T2, MGS20-T2